dt-bindings: iio: accel: adxl345: add interrupt-names

Add interrupt-names INT1 and INT2 for the two interrupt lines of the
sensor.

When one of the two interrupt lines is connected, the interrupt as its
interrupt-name, need to be declared in the devicetree. The driver then
configures the sensor to indicate its events on either INT1 or INT2.

If no interrupt is configured, then no interrupt-name should be
configured, and vice versa. In this case the sensor runs in FIFO BYPASS
mode. This allows sensor measurements, but none of the sensor events.

Signed-off-by: Lothar Rubusch <l.rubusch@gmail.com>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://patch.msgid.link/20241225181338.69672-4-l.rubusch@gmail.com


Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>