Merged TI feature connectivity into ti-linux-5.4.y

TI-Feature: connectivity
TI-Branch: connectivity-ti-linux-5.4.y

* 'connectivity-ti-linux-5.4.y' of ssh://bitbucket.itg.ti.com/lcpdpublicdom/connectivity

: (45 commits)
  HACK: arm64: dts: ti: am654-base-board: Add PHY pattern partition
  HACK: arm64: dts: ti: k3-j721e-som-p0: Add PHY pattern partition
  HACK: arm64: dts: ti: k3-j7200-som-p0: Add PHY pattern partition
  HACK: mtd: spi-nor: Look for PHY pattern partition
  spi: cadence-qspi: Tune PHY to allow running at higher frequencies
  spi: cadence-qspi: Use PHY for DAC reads if possible
  arm64: dts: ti: k3-j721e: Pulldown DQS on OSPI
  mtd: spi-nor: tell the controller the read op for calibration
  mtd: spi-nor: refactor read op creation to make a template op
  spi: spi-mem: allow telling controllers the op to use for calibration
  mtd: spi-nor: set maximum frequency for SFDP reads at 50MHz
  spi: spi-mem: allow specifying the maximum frequency on an op
  arm64: dts: ti: am654-base-board: Set OSPI frequency to 25MHz
  arm64: dts: ti: k3-j721e-som-p0: Set OSPI frequency to 25MHz
  arm64: dts: ti: k3-j7200-mcu-wakeup: Add node for OSPI0
  arm64: dts: ti: k3-j7200-som-p0: Add nodes for OSPI0
  mtd: spi-nor: allow using MT35XU512ABA in Octal DTR mode
  mtd: spi-nor: add support for Cypress Semper flash
  mtd: spi-nor: disable Octal DTR mode on suspend.
  mtd: spi-nor: perform a Soft Reset on shutdown
  ...

Signed-off-by: LCPD Auto Merger <lcpd_integration@list.ti.com>