msm_serial_hs: Programming Auto RFR Ctrl bit

1.)Disable the auto RFR before forcibly making the RFR
line HIGH from the driver to avoid the controller
changing it's state with out driver's knowledge and
enable the auto RFR instead of making the RFR line
forcibly LOW.So that controller will make it LOW
based on the rx FIFO condition
2.)Due to unexpected data received from the client during
clock off sequence, the clock off sequence is going
into wrong state and eventually leads to uart hardware
mess up
This patch doesn't allow any data from the client during
clock off sequence is in progress

CRs-Fixed: 546216
Change-Id: Ib5b3099dbf05d71ef05c1269788ee6c56353b037
Signed-off-by: Dilip Kota <c_dkota@codeaurora.org>
Signed-off-by: Dilip Kota <c_dkota@codeaurora.org>